Showing posts with label Guidelines. Show all posts
Showing posts with label Guidelines. Show all posts

Saturday, May 29, 2010

RV Winterizing 101 - Part 1

It's always sad to come to the realization that another camping season is winding down. Part of this realization is preparing the RV for winter storage, so it will be ready to go camping again next spring. My guess is that most RV owners, especially those in cold climate regions, refer to this winter storage preparation as winterizing your RV. When you hear the term "winterizing" the first thought that comes to mind is to protect the RV water system from potential damage caused by exposure to freezing temperatures. Frozen and damaged water lines are in fact the most common problem related to not winterizing your RV, or not properly winterizing your RV; but there is more to winterizing your RV than just protecting the water system from freezing.

The English dictionary definition for "winterize" is to prepare something, especially a house or an automobile, to withstand cold winter conditions. What I find interesting about this definition is that your RV is essentially a house and automobile combined. With that said, winterizing your RV would entail more than just preparing the water system for cold winter conditions. We would need to be concerned with preparing the RV's interior, exterior, chassis, and plumbing from the harsh winter months.

In this article, I will discuss some tips for preparing the RV interior, exterior and the chassis for cold winter storage, and next week I will discuss preparing the plumbing system for the cold winter storage.

RV Interior

When RVs are stored for the winter it's not uncommon for mice and squirrels to make their winter home in the RV. These animals are notorious for chewing through vehicle wiring, plastic and rubber components, resulting in extensive damage to the RV. If it's a motorized RV start the engine periodically to keep any chewing squirrels out of the engine compartment area.
Possibly, the most important step is to try and prevent mice and other rodents from being able to access your RV. This can be difficult because they can enter the RV through some very small openings. Start by inspecting the underside of your RV for any gaps or holes. Fill these gaps using silicone or expanding foam. A word of caution, if you never used expanding foam before, you should experiment with it on something other than your RV first. When it dries it can expand a great deal more than you expect. Next, open drawers and cabinet doors inside your RV. Look in all of the corners and crevices, especially where plumbing and wiring enter the RV. If you can see any daylight mice can get in. Fill these areas with silicone or foam.

Remove all food from the RV when it's being stored and thoroughly clean the RV to remove any remnants of food that might attract mice and other rodents. Some people say mothballs help deter mice from making their home in your RV, and others say an alternative to mothballs is dryer sheets, like Bounce. I have talked to people who swear they work and the smell is much more pleasant. If you are close to where your RV is being stored you may want to use conventional mouse traps and check for mice every week or so.

Next you should defrost the freezer compartment and clean the refrigerator. Leave the doors open and place baking soda in the compartments to absorb any odors. If the RV is in long-term storage, and won't be plugged in to electricity, it's a good idea to turn off the main breaker in the distribution panel. Turn the LP gas supply valve off at the cylinder(s) or tank. Close the window blinds to avoid sun exposure to the carpet, drapes and upholstery. Leave doors drawers and cabinets open. Clean the A/C filter(s). If you have vent covers installed on the overhead vents, that prevent rain from getting inside, leave them cracked open to allow for some ventilation. Remove any dry cell batteries from devices like smoke alarms, clocks etc.

RV Exterior

When you store your RV outside for extended periods the exterior begins to show signs of wear, caused by the constant exposure to the elements. Ozone in the air and ultraviolet, (UV) rays from the sun start to take their toll. Ozone causes the paint to fade and makes products like rubber and vinyl dry out, crack, and start to deteriorate. The UV rays from the sun make this aging process happen quicker. Before you store your RV you need to give the exterior a thorough cleaning. Whenever I'm washing or cleaning anything, whether it's an automobile or the RV, I start from the top and work my way down. It's a good idea to clean the RV roof before putting the RV in storage too. The type of roof your RV has will determine the cleaner you will need to use. Wash the exterior and if you're really motivated wax it, using a quality wax formulated for the type of exterior surface your RV has. A good coat of wax protects your RV finish the same as it does an automobile. When you are cleaning the RV exterior inspect all roof seams, body seams and window sealant for any cracks and openings that would allow water to get in. Consult your RV dealer for sealants compatible with these materials and re-seal as required.

Don't forget to clean the awning fabric, and let it dry completely before storing it. If you have a pop-up or hybrid trailer make sure all of the tenting material is clean and dry before storage.
Ideally you should try to store your RV under a covered area and on a solid surface like concrete. If this isn't possible avoid parking under trees and in tall grass, fields or wooded areas. If the RV won't be parked under some type of covered shelter you may want to invest in a cover. Covering your RV can be a logical and cost effective way to help protect your investment. If you decide to use a cover make sure it is made of a breathable material.

Service all locks with a spray lubricant and lubricate all hinges. Insects are attracted to the odorant added to LP gas. You may want to cover LP gas appliance vents to prevent insects from making their winter home inside these vents. If you do cover the vents, remember to remove the cover next spring.

RV Chassis

Just like the exterior of the RV, the tires on your RV can be damaged by the harmful UV rays from the sun. Inflate the tires to the manufacturer's recommended pressure and cover the tires with covers that will block out the sunlight. Place something like a piece of wood between the ground and the tires. Frozen ground and petroleum based surfaces, like asphalt, can damage tires over time. Make sure that whatever you use to block the tires is larger than the footprint of the tire. No portion of the tire should hang over the edge of the tire block; this can cause internal damage to the tire. For trailers, chock the wheels front and rear. If you are storing a pop-up outdoors angle the tongue downward to assist in snow and water run-off.

Battery maintenance is an important part of winter storage preparation. If you plan to start the unit while in storage, and to periodically plug the unit into shore power leave the batteries in the unit. Plugging it into shore power once a month for about eight hours will help keep the coach batteries topped off. At a minimum you should check and adjust the water levels in all batteries and make sure the batteries are fully charged. A discharged battery will freeze much quicker than a fully charged battery. If the RV is in long-term storage it's better to remove the batteries and store them where they will not freeze. In either case keep the batteries fully charged when they are in storage.

Note: If your converter charger doesn't have a three stage charging system (or storage maintenance mode) don't leave the unit plugged in constantly. This could overcharge the batteries and deplete the electrolyte levels.

If it's a motorized RV you should fill the fuel tank prior to storage and add a fuel stabilizer. Run the engine and the generator long enough for the stabilizer to get through the entire fuel system. Change the oil and oil filter on the engine and the generator prior to storage. Acids accumulate in used oil and can corrode engine bearings, especially while sitting for long periods of time. If possible exercise the generator for at least two hours every month with a minimum of a ½ rated load on it. Consult your generator owner's manual for load ratings.

In my next article I will discuss how to prepare the RV plumbing system for the cold winter months.

Monday, May 24, 2010

Advice For Damp Homes

Is your home damp?

A damp house can encourage mould growth and mites which can increase the risk of illness. Here are some tips to identify the causes and what to do.

Water ingress

Damp caused by water penetrating from outside has a couple of tell tale signs. Firstly water penetrating through brickwork will extract the salts and leave a white deposit called efflorescence. Secondly a leak will leave a tide mark. As the problem gets worse further ring marks will appear. It is a good idea to mark the outer ring and monitor to see how it progresses. Often it takes several attempts to solve a leak as water can travel in unusual routes.

If either of these signs are apparent check for obvious causes such as a leaking or blocked gutter/downpipe, objects stacked against the external wall bridging the damp proof course, leaking pipes, dripping overflows, damage to roof or missing tiles. If fixed quickly there will be less damage to the fabric of the building. For more serious problems or no obvious signs get an expert in. If you suspect the damp proof course is damaged or there is not one advice from a damp-proofing specialist will be required.

Condensation

A common cause of damp is condensation. Condensation occurs when moisture in the air hits a cold surface and condenses. This is why it is more a problem in cold weather. Signs of condensation are mould growth in the corners of a room, around windows, behind wardrobes/cupboards, above cookers and baths and sometimes on north facing walls.

It is essential to treat any mould existing first. Wash off mould with a fungicidal wash following the manufacturers instructions. Bleach can also be used but may damage surfaces and care is required not to get it on the skin. Do not brush or vacuum up mildew as is will disturb the spores. Always dry clean clothes and shampoo carpets.

Redecorate surfaces with a quality fungicidal paint to help reduce mould reoccurring.

The only way to reduce condensation is to follow three simple steps.

1. Reduce moisture produced.

2. Insulate

3. Ventilate

There are very simple ways to reduce moisture in the home by simply changing our lifestyle. These tips will make a big difference to the moisture produced in the home.

o Vent tumble dryers (unless self condensing)

o Dry washing outside. If this is not possible hang washing up in the bathroom and leave a window open

o Try not to use portable gas heaters as they add more moisture in the air

o Cover saucepans when cooking.

o Do not leave a kettle to continuously boil.

If a home is warmer it reduces the likeliness of condensation. Insulation and draughtproofing is the most effective way of helping to keep your home warm and save money on our heating bills. Home improvements such as secondary or double glazing will reduce heat loss but you must ensure that windows are fitted with trickle vents. Cavity wall and loft insulation are also very effective. Check with you local council to se if any grants are available, pensioners and low income families usually receive substantial grants. There are companies that will carry out works on a grant scheme. In very cold weather low background heating on all day will help keep the fabric of the building warm and reduce moisture condensing on cold spots. Here are some essential tips of what not to do:

o Do not draughtproof the kitchen or bathroom

o Do not completely block up chimneys (always fit an air brick or grill)

o Do not block up ventilators

o Do not cover eaves ventilators when laying loft insulation

o Do no forget to draughtproof the loft hatch

It is possible to ventilate your home without making it draughty. Here are a few tips:

o If windows have trickle vents do use them. If your windows don't look into the cost of fitting them.

o Leave a gap between the back of furniture and an external wall. Where possible position furniture on internal walls.

o Open kitchen and bathroom windows and close the door when in use. If you have an extractor fan please use them they are very cheap to run. If you don not have an extractor fan in these rooms consider fitting them.

o When in a room open a small window.

o If the condensation is worse in the loft or ceiling below check the eaves ventilators are not blocked. If none are fitted consider fitting some. Some eaves ventilation systems are hard to spot so close inspection is required. Always check what material a soffit is made from before purchasing a ventilator as some soffits in older houses are made from asbestos.

If you approach reducing condensation from the three simple steps you should find a dramatic difference. If no improvements are made seek professional advice.

Wednesday, April 14, 2010

How to Maintain Hot Tubs

Hot tub gives you the whole reason to revitalize your lost strength and energy in day to day life. It is the pure healthy manner which offers you a great fun activity too. In this fast changing life, the necessity of hot tubs has become a basic need. In fact, hot tubs have given a reason to be with families and friends closer to you. Just soak into the hot tub with your near and dear ones spend a quality time with them. If you are planned to install your own hot tub at home, check different options that are available in the market suiting your needs and requirements. You can choose the styling for your hot tub that showcases your personality and choice.

Once you get installed a proper hot tub at home, time for now to take appropriate precautions to keep it in order. For maintaining the usability and importance of hot tub, you can do a lot in reality. First of all, you must keep it really clean and dry when it is not in use. Use soft cloth to dry it in case the water facility is not connected in it.

Fro maintaining this exercise pool, you must also not burden your hot tub. Always remember its capacity and not over burden it otherwise it may crack up later. If you have portable hot tub or small hot tub at home, it becomes really easy to make it usable and effective. To check its usability, you can also take some professional help to give you some really beneficial advice and information. Try to replace the hot tub accessory regularly.

Hot tubs offer you a great way to health. Therefore, proper maintenance and care is demanded urgently. Also, you can also save your money after that too.